PharmaOnco™ Mouse IgE ELISA Kit (CAT#: ITS-0622-YT378)

Pre-coated, ready to use 96-well strip plate
Plate sealer for 96 wells
Standard
Sample/Standard Dilution Buffer
Biotin-labeled Antibody (Concentrated)
Antibody Dilution Buffer
HRP-Streptavidin Conjugate (SABC)
SABC Dilution Buffer
TMB Substrate
Stop Solution
Wash Buffer (25 x concentrate)
Instruction manual

1.Microplate reader (wavelength:450nm)
2.37 °C incubator
3.Automated plate washer
4.Precision single and multi-channel pipette and disposable tips
5.Clean tubes
6.Deionized or distilled water

10 pg/mL

100 μL

Pre-coated

Bring all reagents and samples to room temperature for 20 minutes before use.
Wash Buffer
Standards
Preparation of Biotin-labeled Antibody Working Solution
Preparation of HRP-Streptavidin Conjugate (SABC) Working Solution

Set standard, test samples (diluted at least 1/2 with Sample Dilution Buffer), control (blank) wells on the pre-coated plate respectively, and then, records their positions.Wash plate 2 times before adding standard, sample and control (blank) wells!
Prepare Standards
Add Samples
Incubate
Wash
Biotin-labeled Antibody
Wash
HRP-Streptavidin Conjugate (SABC)
Wash
TMB Substrate
Stop
OD Measurement

Store Standard at -20°C; Store other components at 2-8°C.

Stable as supplied until expiry date on label.

Tested for sterility

Restrictions for research use only. Intended for use by laboratory professionals.

1.Wash plate 2 times before adding Standard, Sample and Control wells!
2.Add 100 µL standard or sample to each well and incubate for 90 minutes at 37 °C.
3.Aspirate and wash plates 2 times.
4.Add 100 µL Biotin-labeled antibody working solution to each well and incubate for 60 minutes at 37 °C.
5.Aspirate and wash plates 3 times.
6.Add 100 µL SABC Working Solution into each well and incubate for 30 minutes at 37 °C.
7.Aspirate and wash plates 5 times.
8.Add 90 µL TMB Substrate Solution. Incubate 10-20 minutes at 37 °C.
9.Add 50 µL Stop Solution. Read at 450nm immediately and calculation.